Log Cabin Online

For most ramrods with a 10-32 thread size. Adapts to ramrods, instantly converting a standard ramrod to a hard working range rod. Pivoting power handle forms a strong T-handle and provides extra power when seating projectiles. Also enable you to pull stubborn projectiles or hung up jags. The hard plastic pivoting T-handle folds neatly into the ramrod, permitting you to use this power handle attached to your ramrod when carried in thimbles, under the barrel.

Ramrod handle for muzzle loaders. A screw-on handle for ramrods for loading and cleaning. Gives a better grip on the rod to seat the ball or while cleaning. 1-3/4" diameter. Threaded 8 x 32 or 10 x 32.

Includes a 3/8" dia. solid brass shaft 5" long, which encloses a nipple pick at the end. The 2" dia. wood ball holds a short starter and a brass stud for attaching to a hunting bag. Ball features a flat side with a recess to slip over ramrod, functioning as a palm saver to help seat a tight bullet those difficult last few inches.

Solid brass seater and starter shaft.  Concave seater and starter for centering on ball or bullet.  Large, solid 2" hardwood ball.  Solid tapered brass bore guide to keep shaft centered in bore.  Fits all calibers from .40 thru .58.  Made in USA.

 Thompson Centers' new composite T-handle short starter is a lightweight and compact short starter with a "palm saver" built right into one of the ends.  It also features a removable seating end which allows you to convert your ramrod into a work rod.  By removing the seating end of the rod, and screwing the T-handle onto a standard ramrod it will extend the length of your ramrod for easier seating of projectiles, especially during continuous shooting at the range.  It will provide you with extra leverage for firmer more uniform seating.  It effectively converts your ramrod to a range rod.

Features a 1-3/4" diameter wood ball with solid brass short starter. 5-1/2" long starter with brass tip for increased durability. Overall length 7". 5/16" for .32 - .38 caliber with solid brass rod.

Features a 1-3/4" diameter wood ball with solid brass short starter. 5-1/2" long starter with brass tip for increased durability. Overall length 7". Available in three sizes: 3/8" for .40/.45 caliber, 7/16" for .50 caliber, 1/2" for .54 caliber.

These solid brass guides come sized for specific rod diameters. The tapered end will fit a range of bore sizes and eliminate ramrod wear at the muzzle to prolong the accurate life of your valuable rifle. Available in three sizes: 1/4" for .32 caliber & larger, 5/16" for .38 caliber & larger, 3/8" for .45 caliber & larger.

Small and light enough to be carried in a pocket or pouch, this little tool can be a great help in removing a rod stuck in a rifle barrel. Just squeeze the tool around the rod to create a handle. Can also be used as a comparison calipers (not calibrated) for measuting inside or outside dimensions. 

This handy tool will make easy work of removing ramrods stuck in the bore during cleaning, ball pulling, etc. Place tool over the stuck ramrod and lift. Fits rods up to 1/2" diameter. The leather padded, grooved jaws lock firmly in place. The more you pull the tighter they grip. Greatly increases effective force applied without damage to the rod.